Your quotation

Choose your worktop:

Worktop measurements

Measure the length (mm) & width (mm) of each worktop including islands and breakfast bar and input them sizes into the boxes to the right.

length 1
x
-
length 2
x
-
length 3
x
-
length 4
x
-
+ add another length
Total area:
0 sq m

Worktop thickness

Choose between

Worktop thickness

Radius Corners, mitres and cut outs for pop-up plugs

Radius corners are when we cut the stone to follow a rounded corner unit or add shape to a breakfast bar.

Two mitres are needed for each waterfall edge/ granite or quartz end panel.

If your having a pop-up plug you will require a cut out.

how many

Polished cut-outs

These are cut-outs for under-mounted sinks and include the hole for a tap. Take a look at our our range of Franke sinks and taps.

how many

Unpolished cut-outs

These are cut-outs for hobs and surface mounted sinks.

how many

Polished edges

Standard chamfer is included as standard. Other edges are available for an additional fee. Pencil Edge, Shark Nose, Ogee and Half bullnose.

polished edge
edge length (mm)

Drainer Grooves

These are five straight grooves (1 set) in the worktop at one side of the sink which act as a draining board.

how many sets

Upstands

These can be used instead of tiling the wall. Measure the total length of upstans required.
Normally around 100mm in height.

total length

Windowsills and splashbacks

This is the granite panel that can be used behind hob, range and sink to protect the wall from splashes. You can also have full wall splashbacks which are positioned on top of the worktop to the underside of the wall unit.

Measure the length (mm) and width (mm) of each splash back and windowsill that you require and input them into the boxes to the right.

length 1
x
-
length 2
x
-
length 3
x
-
+ add another length
Total area:
0 sq m

Templating & Installation service

This is a service where we come out and make a life size template of the worktops. Make it all at the workshop and come back and install them.

Service
  • yes
  • no
    • calculating your quotation...